Advanced energy absorbing components for improved effectiveness of low mass vehicle restraint systems

Muser, M.; Krabbel, G.; Prescher, V.; Dragan, A.; Walz, F.; Niederer, P.

Affiliations

¹Working Group on Accident Mechanics, University of Zurich and Swiss Federal Institute of Technology, Switzerland

²Institute of Road Traffic Safety, Technical University of Berlin, Germany

³PARS GmbH, Alzenau, Germany

⁴Institute of Legal Medicine, University of Zurich, Switzerland

⁵Institute of Biomedical Engineering, University of Zurich and Swiss Federal Institute of Technology, Switzerland

Abstract

Given an adequate structural design, low mass vehicles can exhibit a level of passive safety comparable to their heavier counterparts, even in frontal crashes against vehicles twice their mass. The high car mean acceleration levels (50 g) and Δv (20 m/s) observed in such collisions demand for an optimisation of their restraint systems. It has been shown in earlier tests that especially the distance between chest and steering wheel, which is defined by ergonomical constraints, is insufficient in a low mass vehicle under these crash circumstances. The steering wheel must therefore yield during the crash, preferably through an energy absorbing mechanism. The belt system must in return allow for an increased forward displacement of the occupant without intolerable belt force levels.

Optimisation of the key components of such a restraint system is solvable only with the extensive use of computer simulation in combination with single component tests and sled experiments. A restraint system meeting the occupant protection requirements is presented. In sled tests, a collision with a Δv of 77 km/h was simulated, yielding tolerable injury protection criteria for the Hybrid III 50 % dummy.

Cited Works (5)

Year	Entry
1995	Kaeser R, Muser M, Spiess O, Frei P, Guenat JM, Wingeier L. Passive safety potential of low mass vehicles. In: Proceedings of the 1995 International IRCOBI Conference on the Biomechanics of Impact. September 13-15, 1995; Brunnen, Switzerland.337-352.
1974	Gloyns PF, Mackay GM. Impact performance of some designs of steering assembly in real accidents and under test conditions. In: Proceedings of the 18th Stapp Car Crash Conference. December 4-5, 1974; Ann Arbor, MI. Warrendale, PA: Society of Automotive Engineers:1-27. SAE 741176.
1993	Niederer PF, Walz FH, Kaeser R, Brunner A. Occupant safety of low-mass rigid-belt vehicles. In: Proceedings of the 37th Stapp Car Crash Conference. November 7-8, 1993; San Antonio, TX. Warrendale, PA: Society of Automotive Engineers:1-12. SAE 933107.
1993	Nilson G, Håland Y. A force-limiting device to reduce the seat-belt loading to the chest and the abdomen in frontal impacts. In: Proceedings of the 1993 International IRCOBI Conference on the Biomechanics of Impact. September 8-10, 1993; Eindhoven, The Netherlands.379-393.
1991	Horsch JD, Viano DC, DeCou J. History of safety research and development on the General Motors energy-absorbing steering system. In: Proceedings of the 35th Stapp Car Crash Conference. November 18-20, 1991; San Diego, CA. Warrendale, PA: Society of Automotive Engineers:1-46. SAE 912890.